top of page

Finally ready for release "Raptor v4" .stl files out

There were a lot of questions for buying 3d plans for model mutirotor  "Raptor"!

I did not want to put plans online until model is not fully tested!!!!

 

STL. of complete model is ready for download with a symbolic price:

 

... (donation) is

 

8.99 USD

 

 

I also created a group on the world biggest forum "RC Groups", where you can read some useful things.

 

Price of .STL plans is very small compared to 250 hours at the computer - how much I needed to design and test this model, so I kindly ask do not share plans (copiright) on Internet, in the interest of developing new models and redesign this model if needed.

 

If you want .stl files - donation of $8.99 you can pay to my paypal acc. 

 

krbelcar@gmail.com

 

After payment confirmation I'll send You complete STL files for final model "Raptor v4"

Below you can read some information about my setup...and see few picc and videos of previous versions multirotor "Raptor"... also progress in design from version 1 to version 4

"Raptor v4" is model inspired by (DJI Inspire) - printed on my 3D printer combined black and white color,  material is ABS-PLA

 

Selling kit includes:

- Printed plastic parts (ABS-PLA), color sheme like in pictures (possible to print in other colors - You contact me to see possibilities)

- 1 countinuus and hacked servo motor with complete electronic to retract arms (plug-n-play to spare channel on RX)

- set carbon tubes for hands

- 4 +2 bearings for hands and retracts

- All necessary screws

 

Specifications:

 

- empty weight - no electronics 1100g

- diagonally from the prop to the prop 700 mm (can be easily increase by placing longer carbon tubes 24ODx22IDmm)

- material combination of ABS and PLA, black and white

(Electronics is not included in the package)

 

To complete model You need electronics:

- 4 motors 51xx - 52xx  500-800kv (4215 650kv)

- 4 ESC 35-40A- 4 props 14x4.5 14x6

- multirotor controller set- RX/TX min 6ch

- battery 4/6S  5000/10000mah(Electronics is not included in the package)

- all necessary wires

 

 

In my test model I use:

- controller APM2.6 ArduPilot Mega w/Ublox NEO-6M GPS External Compass Power Module USB Cable

- motors Rctimer 5010-620KV Multicopter Brushless Motor

- ESC Rctimer Mini ESC40A OPTO BLHeli Firmware

- props Gemfan 1447 Carbon Nylon CW/CCW Propeller APC For RC Multirotor

- LED strips  Mini RC 12LEDs 5050 5630 3528 Strip Lights + JST Connector For FPV Quadcopter

- wires 22 Gauge AWG Black Red 100cm

 

Available in:  Shop

 

bottom of page